VeeCAD
https://veecad.com/yabb/YaBB.pl
General Category >> VeeCAD General Discussion >> Strip Grey setting doesn't stick
https://veecad.com/yabb/YaBB.pl?num=1169085223

Message started by sixeyes on Jan 18th, 2007 at 1:53am

Title: Strip Grey setting doesn't stick
Post by sixeyes on Jan 18th, 2007 at 1:53am
If I change the Strip Grey setting it isn't remembered the next time I start VeeCad.
Just downloaded the latest 2.5.0.0

Title: Re: Strip Grey setting doesn't stick
Post by Roger Lascelles on Jan 18th, 2007 at 12:37pm
Thanks for the report!

Strip Grey in Edit -> Settings are stored OK for me on Free Version 2.5.0.0 .  The code is unchanged  since 2.3.0.0 (16 Sept 2006).

However, when you start VeeCAD again, the setting is pulled back to a limit of 200.  I'll remove this limit in the next release.  Can you tell me if this limit of 200 describes your problem?

Is anyone else having a problem with strip grey settings?

Title: Re: Strip Grey setting doesn't stick
Post by sixeyes on Jan 18th, 2007 at 12:39pm
Ok. I was trying to use a value of ~220. I found the default too harsh.

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.