VeeCAD
https://veecad.com/yabb/YaBB.pl
General Category >> VeeCAD General Discussion >> Tracks and cuts only
https://veecad.com/yabb/YaBB.pl?num=1170168170

Message started by sixeyes on Jan 30th, 2007 at 2:42pm

Title: Tracks and cuts only
Post by sixeyes on Jan 30th, 2007 at 2:42pm
When making a circuit with veroboard I like to make all the track cuts first.

Could VeeCAD produce a reverse view (i.e. from underneath the board) and ONLY show the cuts (i.e. No components)?

Title: Re: Tracks and cuts only
Post by Roger Lascelles on Jan 31st, 2007 at 2:58am
I will add a "Tracks and Breaks Only" option to print settings.  This should be in the next release or so.

Title: Re: Tracks and cuts only
Post by MatS on Feb 18th, 2007 at 1:40pm
The tracks and cuts - can it be reversed so that it looks the same as the rear of the board rather than a view through it from the front? That would be very useful!

Title: Re: Tracks and cuts only
Post by Roger Lascelles on Feb 18th, 2007 at 9:16pm
I will do.

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.