VeeCAD
https://veecad.com/yabb/YaBB.pl
General Category >> VeeCAD General Discussion >> Improvement - highlight overlapping links
https://veecad.com/yabb/YaBB.pl?num=1172243226

Message started by MatS on Feb 23rd, 2007 at 3:07pm

Title: Improvement - highlight overlapping links
Post by MatS on Feb 23rd, 2007 at 3:07pm
Another suggestion - currently it is possible to have links on a board where one is completely covered by another. In other words, you can have, say, a link from track 4 to 6 and a link from 2 to 5 in the same vertical column. Obviously this is going to be error-prone to impossible to build so could veecad be modified to highlight the overlap? I know some people will not see much point in this but it could save some headache after a tired editing session!

Also - can the print options be changed to send more than one copy to the printer? I'm using the prints like a silkscreen and making >1 board at a time.

Mat

Title: Re: Improvement - highlight overlapping links
Post by Roger Lascelles on Feb 24th, 2007 at 12:32am
Thanks Mat, these are fresh ideas.  Now on my list.

Title: Re: Improvement - highlight overlapping links
Post by MatS on Feb 26th, 2007 at 10:57am
Glad to be of service ;-)

Any idea when then next release will be out?

Mat

Title: Re: Improvement - highlight overlapping links
Post by Roger Lascelles on Feb 26th, 2007 at 10:55pm
Say 3 to 6 weeks.

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.