VeeCAD
https://veecad.com/yabb/YaBB.pl
General Category >> VeeCAD General Discussion >> Updating a board
https://veecad.com/yabb/YaBB.pl?num=1208284466

Message started by sixeyes on Apr 15th, 2008 at 7:34pm

Title: Updating a board
Post by sixeyes on Apr 15th, 2008 at 7:34pm
I don't know if you can help but...

I generated a layout in VeeCAD and built the board. I then found I needed to modify the design. This I did but it's difficult to spot the changes made to the board.

Is there any way you could show changes to a layout? Colours / Layers etc

Title: Re: Updating a board
Post by Roger Lascelles on Apr 16th, 2008 at 4:22am
Good idea.  Perhaps we need an option to compare the editor layout against another project file - and highlight the differences

I will put this on the list of possible enhancements for the future, but remember, the list is very long.

Title: Re: Updating a board
Post by sixeyes on Apr 16th, 2008 at 4:32pm
Would it be easier (for you) to allow components to be coloured and/or layered so that I could add new components in a new colour / layer?

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.