VeeCAD
https://veecad.com/yabb/YaBB.pl
General Category >> VeeCAD General Discussion >> Direction of strips
https://veecad.com/yabb/YaBB.pl?num=1213077007

Message started by sixeyes on Jun 10th, 2008 at 6:50am

Title: Direction of strips
Post by sixeyes on Jun 10th, 2008 at 6:50am
Is it possible to change the strips to be vertical instead of horizontal?

I've got a board with lots of narrow strips and it would be easier to work going across the screen than down.

Iain

Title: Re: Direction of strips
Post by Roger Lascelles on Jun 10th, 2008 at 12:55pm
Vertical strips are a very low priority, I am afraid.

If I ever make VeeCAD V3, it might have a more general architecture which handles this.

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.