Roger,
In the "show" group of buttons on the "appearance" tab of the "print setup" window, would it be possible to add a check button to allow text mode characters (normally placed on the component side) to appear on the track side of the board?

I have recently had a little accident where a large number of "fronts" and "backs" of various layouts were dropped.  It took quite a considerable amount of time to pair them up again.

To be able to repeat the board reference on the component side to appear on the reverse would be very useful.

Regards

Brian

Hello Brian

Thank you for this practical idea. I have put your request on the list. I can't make a promise about when or if this feature will be added.