VeeCAD
https://veecad.com/yabb/YaBB.pl
General Category >> VeeCAD General Discussion >> Double-sided 4x6cm Chinese donut board pattern
https://veecad.com/yabb/YaBB.pl?num=1587297188

Message started by FrankB on Apr 19th, 2020 at 12:53pm

Title: Double-sided 4x6cm Chinese donut board pattern
Post by FrankB on Apr 19th, 2020 at 12:53pm
Attached should be a new board pattern that you can put into your VeeCAD Patterns folder. Before you do, remove the ".txt" suffix because this system does not allow ".per" as a filename suffix. I also see you will have to "sort out" the mess this system makes of the original filename. Such is life!

The original filename was Chinese Donut (5x7cm).per in case you're baffled.

It is for a double-sided plated-through tinned 14x20 hole Chinese donut board you can buy in places like Ebay. It is green in colour, is marked with letters for the columns but no row numbering. It is also marked with "4 X 6CM".

I hope you find it useful.

To follow are more postings relating to similar green double-sided donut boards also from China.

https://veecad.com/yabb/YaBB.pl?action=downloadfile;file=Chinese_DS_Donut__4x6cm__per.txt (18 KB | 92 )

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.