Welcome, Guest. Please Login or Register
VeeCAD Stripboard Editor
   
  HomeHelpSearchLoginRegister  
 
Page Index Toggle Pages: 1
Send Topic Print
Strip Grey setting doesn't stick (Read 3462 times)
Iain
Junior Member
**
Offline


Your message here...

Posts: 54
Guildford, Surrey, England
Strip Grey setting doesn't stick
Jan 18th, 2007 at 1:53am
 
If I change the Strip Grey setting it isn't remembered the next time I start VeeCad.
Just downloaded the latest 2.5.0.0
Back to top
 
 
IP Logged
 
Roger Lascelles
Administrator
*****
Offline



Posts: 461
Clifton Springs, Australia
Re: Strip Grey setting doesn't stick
Reply #1 - Jan 18th, 2007 at 12:37pm
 
Thanks for the report!

Strip Grey in Edit -> Settings are stored OK for me on Free Version 2.5.0.0 .  The code is unchanged  since 2.3.0.0 (16 Sept 2006).

However, when you start VeeCAD again, the setting is pulled back to a limit of 200.  I'll remove this limit in the next release.  Can you tell me if this limit of 200 describes your problem?

Is anyone else having a problem with strip grey settings?
Back to top
 

Roger
 
IP Logged
 
Iain
Junior Member
**
Offline


Your message here...

Posts: 54
Guildford, Surrey, England
Re: Strip Grey setting doesn't stick
Reply #2 - Jan 18th, 2007 at 12:39pm
 
Ok. I was trying to use a value of ~220. I found the default too harsh.
Back to top
 
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print