Apr 19th, 2024 at 5:16am
  
  Welcome, Guest. Please Login or Register
 VeeCAD Stripboard Editor
   
 
  HomeHelpSearchLoginRegister  
 
  VeeCAD › General Category › VeeCAD General Discussion › Direction of strips
(Moderators: , )
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Direction of strips (Read 2616 times)
Iain
Junior Member
**
Offline


Your message here...

Posts: 54
Guildford, Surrey, England
Direction of strips
Jun 10th, 2008 at 6:50am  
Is it possible to change the strips to be vertical instead of horizontal?

I've got a board with lots of narrow strips and it would be easier to work going across the screen than down.

Iain
Back to top
 
 
IP Logged
 
Roger Lascelles
Administrator
*****
Offline



Posts: 491
Clifton Springs, Australia
Re: Direction of strips
Reply #1 - Jun 10th, 2008 at 12:55pm  
Vertical strips are a very low priority, I am afraid.

If I ever make VeeCAD V3, it might have a more general architecture which handles this.
Back to top
« Last Edit: Jun 11th, 2008 at 12:44am by Roger Lascelles »  
Roger
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
 
  « Home ‹ Board Top of this page

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge