Sep 21st, 2021 at 9:16am
  
  Welcome, Guest. Please Login or Register
 VeeCAD Stripboard Editor
   
 
  HomeHelpSearchLoginRegister  
 
  VeeCAD › General Category › VeeCAD General Discussion › Snap issue when placing text
(Moderators: , )
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Snap issue when placing text (Read 226 times)
Ed
YaBB Newbies
*
Offline


Your message here...

Posts: 2
Snap issue when placing text
Feb 10th, 2021 at 10:35pm  
Snap doesn't allow me to place text (component designator/ values) exactly where I want it. I can't find a way to turn snap off???
Back to top
 
 
IP Logged
 
Roger Lascelles
Administrator
*****
Offline



Posts: 461
Clifton Springs, Australia
Re: Snap issue when placing text
Reply #1 - Feb 11th, 2021 at 4:44am  
Welcome to the forum Ed!

Like you, I find the component text snap to be too coarse. At present there is no way to turn off text snap.

I have planned to change the snap increment to half-cells, which is probably all we need. I can't promise when that feature will get added.
Back to top
 
Roger
 
IP Logged
 
Ed
YaBB Newbies
*
Offline


Your message here...

Posts: 2
Re: Snap issue when placing text
Reply #2 - Feb 11th, 2021 at 6:54pm  
Hi Roger, thanks for replying...

Yes half cell would do. Bit of a hack but I find a leading full stop works most of the time for me.

Ed
Back to top
 
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
 
  « Home ‹ Board Top of this page

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge