Your schematics and netlists look to be high quality. To use the router you need a good positioning of the fixed components, including all those small capacitors. I will get back to you soon with completed layouts, and will try the router over the next few days.

I can make a YouTube video of the manual and/or routed layout procedure for one or other circuit, but only if that does not violate someone's copyright. So let me know if you would like a video, and which circuit.

On the Haible Waveshaper schematic, I see some ground symbols, but the TinyCad tool window shows a blank net name for them. I will set them to 0V or GND, and all will be well. Note that TinyCAD power symbol shapes are cosmetic - you still have to set a net name.

Attached are layouts for your later set of files. These are manually laid out.

Manually, the procedure is:

• print schematic
• place ICs
• allocate power and ground lines and connect to IC pins
• Use Ctrl-F to find a schematic part that connects to an IC pin - say R1
• slide stuff sideways to allocate or remove space
• look above or below an IC to find a free strip when you need a connection point