Welcome, Guest. Please Login or Register
VeeCAD Stripboard Editor
   
  HomeHelpSearchLoginRegister  
 
Page Index Toggle Pages: 1
Send Topic Print
Routing on donut boards (Read 37 times)
Harshana R
YaBB Newbies
*
Offline


Your message here...

Posts: 1
Routing on donut boards
Sep 20th, 2022 at 3:55am
 
Dear all,

I'm using donut boards for all my electronic circuits. On donut boards I want to use links on both sides (I actually do this physically). But VeeCAD only allows me to link on single side. Using wires is not practical as it won't allow me to draw the path I want to take. Can someone help me ?

Thank you,
Harshana
Back to top
 
 
IP Logged
 
Roger Lascelles
Administrator
*****
Offline



Posts: 478
Clifton Springs, Australia
Re: Routing on donut boards
Reply #1 - Sep 20th, 2022 at 12:02pm
 
Hello Harshana!

VeeCAD shows all links the same color and there is no way to indicate which side to place the link. Possibly you could load all the vertical links on top and horizontal links on the bottom. I should mention that if 2 links cross VeeCAD will not see this as a short circuit.
Back to top
 

Roger
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print