Dec 2nd, 2023 at 1:38am
  
  Welcome, Guest. Please Login or Register
 VeeCAD Stripboard Editor
   
 
  HomeHelpSearchLoginRegister  
 
  VeeCAD › General Category › VeeCAD General Discussion › Track editior
(Moderators: , )
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Track editior (Read 277 times)
dcb
YaBB Newbies
*
Offline


Your message here...

Posts: 35
sk23
Track editior
Dec 8th, 2022 at 2:21pm  
I am trying to edit the Radio Spares 276-168 board to put a connecting track across the bottom.
But I cannot lengthen the existing vertical trackby pulling the end down.
It is as if there is a barrier across the bottom or as if the design is confined in a box.
Is there a way of escaping this constraint?
Back to top
 
 
IP Logged
 
HELLI
YaBB Newbies
*
Offline


Your message here...

Posts: 44
Ireland
Re: Track editior
Reply #1 - Dec 9th, 2022 at 12:47pm  
That board is provided as a standard pattern. So if you change it you can no longer buy that board. If you do want to design a new board you can amend the board design using BOARD - SIZE to make it bigger and then using TOOLS - TRACK EDITOR to make changes to the tracks.
I hope this helps.
Back to top
 
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
 
  « Home ‹ Board Top of this page

VeeCAD » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2023. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge